Single-sided type
Double-sided type
Usage Methods
The rubber part of the main body is extended by tightening the clamping bolt using an allen key and clamps the workpiece on the metal part. When unclamped, it returns to its original dimensions due to the compression of the rubber.
Single-sided type / Double-sided type
Set the position where the workpiece is clamped by referring to the mounting dimensions taking into account variations in workpiece dimensions.
The locating for clamping direction can be set using the included locating pin.
You can also clamp the workpiece vertically.(LWC-04 cannot)
Single-sided type / Double-sided type
Component Parts
Single-sided type / Double-sided type
Component Parts | |
1 | Main body (metal part) |
2 | Main body (rubber part) |
3 | Clamping bolt |
4 | Main body (metal part) |
5 | Knock pin φ3 |
Mounting Dimensions
Single-sided type
No. | a (Coarse Thread) | b | c | d |
LWC04 | M4 × 0.7 | – | 4.7 – 4.9 | – |
LWC06 | M6 × 1.0 | φ 3H7 depth 4.5 ± 0.2 | 7.9 – 8.2 | 6 |
LWC08 | M8 × 1.25 | φ 3H7 depth 4.5 ± 0.2 | 10.1 – 10.7 | 8 |
LWC12 | M12 × 1.75 | φ 3H7 depth 4.5 ± 0.2 | 12.4 – 13.2 | 10 |
Double-sided type
No. | a (Coarse Thread) |
b | c | d | Maximum Difference Between Left and Right |
LWCD04 | M4 × 0.7 | – | 4.7 – 4.9 | – | 0.2 |
LWCD06 | M6 × 1.0 | φ 3H7 depth 4.5 ± 0.2 | 7.9 – 8.2 | 6 | 0.3 |
LWCD08 | M8 × 1.25 | φ 3H7 depth 4.5 ± 0.2 | 10.1 – 10.7 | 8 | 0.6 |
LWCD12 | M12 × 1.75 | φ 3H7 depth 4.5 ± 0.2 | 12.4 – 13.2 | 10 | 0.8 |
Cautions
In this product, NBR (synthetic rubber) and adhesive are used in the main body
Do not use solvents such as paint thinner, chlorine-based cutting fluids, or strongly alkaline cutting fluids as these can cause the rubber in the main body to damage.
Do not open wider than the specified opening. Doing so may cause the rubber to break.